Amusement equipment also requires maintenance

5D seat

The manufacturing of large-scale amusement equipment is a necessary amusement project for some amusement parks. Currently, many amusement equipment are suitable for all ages and are deeply loved by everyone. While everyone loves it, the safe operation and maintenance of amusement equipment cannot be neglected. So, how should large-scale amusement equipment manufacturing be maintained and serviced?

1： After diluting and soaking the plastic parts with fiberglass, soap water, disinfectant laundry detergent, bleach powder, etc., wipe them with a soft cloth or brush, rinse them with clean water, dry them with a cleaning cloth, or dry them in the sun. Finally, spray 84 disinfectant to disinfect.

2： The soft sponge part can be cleaned with a soft cloth dipped in soapy water, or placed in sunlight for disinfection.

3： The wooden parts that are resistant to moisture, heat, and do not fade can be washed with soap bubbles, dried in the sun, and then sprayed with 84 disinfectant for disinfection.

4： If rust removal is required for metal parts, a brush can be used to remove floating rust, and a dry cloth can be used to wipe it clean; After being exposed to sunlight, you can buy some colorless Sanhe brand self spray paint and spray it at a distance of about 20 centimeters while sweeping. After it dries, spray it again for protection. Clean, sun dry, and disinfect the paint after it is completely dry.

5： When cleaning the electrical components of the circuit, the first thing to do is to ensure that the power is turned off, and watering is prohibited. Generally, a damp cloth is used to scrub, and after it dries completely, the power is connected.

6： All amusement equipment, outdoor slides, and drill pipes should not have accumulated water after rainy days. If there is, a 4mm diameter hole should be drilled at the lowest point for drainage.

7： If it is an indoor activity room, floor, wall, etc., it should be disinfected with ultraviolet radiation daily and the room should be ventilated regularly. Spray and disinfect with hydrogen peroxide once a week.

8： Of course, while disinfecting, it is also necessary to check whether the connecting parts are firm, whether the metal frequently moves, whether the connecting parts are lubricated, and whether the circuit appliances and ordinary components are damaged.